Ares Chronos FP 110 Manual de instrucciones descargar pdf (Pagina 17)

Initialization

To inialize the helicopter, rst power on the transmier

and then plug in the baery, replace the canopy, and place

the helicopter on the ground, making sure that it is not

moving. The LED on the control unit will blink rapidly for

three seconds to indicate that the helicopter is in bind mode.

Following this, the status LED will turn o while the control

unit inializes the radio connecon.

Aer a radio connecon has been successfully established,

the status LED will blink more slowly while the 6-axis

gyroscope on the control unit inializes. Gyroscope

inializaon will not complete unl the helicopter has

been enrely staonary for roughly ve seconds. Once

this procedure is nished, the servos on the helicopter will

inialize, and the helicopter will be ready for ight. The

status LED will either become solid (indicang LOW rate is

acve) or will blink once per second (indicang that HIGH

rate is acve). For more informaon on LOW/HIGH rates,

please see the corresponding secon of the manual.

The 6-axis mode uses state-of-the-art sensing technology to

provide stabilized ight that is truly revoluonary for single

rotor, ybarless helicopters. In this mode, the posion of the

cyclic sck commands pitch and roll angles. These angles

are limited such that the helicopter will remain stable at all

mes while sll providing fast and maneuverable ight. The

helicopter can be brought back to a stable conguraon at

any me simply by releasing the cyclic sck.

The cyclic trim buons are acve in this mode. They can

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Sin comentarios

Ares Chronos FP 110 Manual de instrucciones Pagina 17